Ducting Or Recirculation Fitting - Ariston HDM 9 IX Handbuch Für Installation, Bedienung Und Wartung

4.4 - Ducting or recirculation fitting

1 - Ducting fitting.
This is possible for all forms of installation:
a) Connect the air outlet to the external ducting system.
b) Remove the activated charcoal filter (if there is one) inside the hood
canopy (see Maintenance).
2 - Recirculation fitting
This is only possible with the air outlet directed upwards. Fit the venting
grille G onto the air outlet (Fig. 25). The activated charcoal filter should
be fitted inside the hood canopy after connection to the power supply.
4.5 - Connection to power supply and checking of good working order
1 - It is absolutely necessary to follow the warnings 3.2, 3.3 and 3.4 of
paragraph 3, concerning safety measures.
2 - Loosen the two locking screws and remove the metal cover (fig.26).
Connect the hood connection to the engine connection (fig.27a). Correctly place the connectors
under the cover and tighten the two locking screws (fig. 27b).
3 - Once electrical connection has been carried out, check that lights, engine and change of speed work
4 - Fit the venting grille and the activated carbon filter, only for filter mode (see Maintenance).
26
Part 2 - USE AND MAINTENANCE INSTRUCTIONS
1 - SAFETY WARNINGS
It is most important that all the warnings shown in paragraph 3 of the Installation
Instructions are strictly observed.
Moreover, pay special attention to the following warnings during the use and maintenance of
the cooker hood:
1.1 - The grease filters and charcoal filters should be cleaned or replaced as recommended
by the manufacturer or more frequently if the hood is used consistently (over 4 hours
per day).
1.2 - When using a gas hob in connection with the cooker hood never leave the burners of
the hob uncovered while the hood is in use or when the pans have been removed.
Switch off the gas before removing the pan, or for just short periods and never leave
27a
S28_26
27b
18
25
S28_27