Ariston HDM 9 IX Handbuch Für Installation, Bedienung Und Wartung Seite 16

4.3 - Installation of the
chimney A
No matter which type of installation is
being used, any wooden shelves in the
area where the hood is to be fitted must
first be removed, drilled and later
replaced.
1 - Drilling the shelves:
a) Using the cardboard template
provided, and taking hole "B" as a point
of reference, drill the shelves along the
central axis to allow the passage of the
chimney. The chimney must be inserted
into the shelves before it is fixed to the
hood canopy C (fig. 12).
b) When installing the ducting version
with the air outlet directed upwards, if the
ducting fan unit is positioned below the
line of shelves it will be necessary to drill a
suitable hole in the top shelf only, to allow
the air ducting pipe to pass through
(fig. 13).
2 - Direction and position of the ducting
fan unit
a) The hood is normally supplied with the air outlet directed
14
U
U
A08_14
replace it on the rear part (fig. 15).
· Air outlet directed towards the wall (fig. 3).
- Remove the plastic frame from the air outlet (fig. 16).
12
13
towards the wall (fig. 3), if it is to be
installed with the air outlet directed
to the right or left (fig. 4a-b), it will
be necessary to change the direction
of the ducting fan unit,
proceeding as follows:
- Unscrew the screws U (fig. 14);
- Turn the ducting fan unit 60° to
the right or left;
- Replace the screws U.
b) The ducting fan unit air outlets
must be arranged according to the
type of installation to be carried
out.
· Air outlet directed upwards
(fig. 2a-b).
- Remove the plastic plug from the upper part of the venting grill and
16
15
16