Assembling The Vacuum Cleaner; Operation - Team ST 6 E Gebrauchsanleitung

Fax +32 2 359 95 50


ASSEMBLING THE VACUUM CLEANER

 Remove all packaging material from the appliance and its accessories.
 Assemble the handle of the flexible hose (G) on the upper part of the tubes (I) and then
assemble the floor brush (J) on the other end of the tubes, as indicated on figures 2-3-4.
 Insert the hose (L) in the connection inlet of the dust collector (M) by having the release
button facing upward, and press until it clicks (Fig. 1). To remove the hose, press its release
button and pull at it.
 The floor brush (J) possesses 2 positions (Fig. 5) which allow you to clean all kinds of
surfaces very easily, simply by changing the position adequately:
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.

OPERATION

 First of all, check if the filters are placed properly in the appliance, as vacuum cleaning
without filter might damage the motor of the appliance irreparably. (see paragraph
FILTERS for their use and installation).
 Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark.
 It is advisable to set the electronic power regulator to MIN before switching the appliance
on. By turning the regulator button, the suction power can be adjusted.
 When you use the floor brush, make longitudinal to and fro movements (do not make
lateral movements) and insist on the places that are dirtier, always keeping the sole of the
floor brush in contact with the surface you want to vacuum. To clean under low pieces of
furniture, hold the handle (G) and make a quarter of a turn with the hinge of the floor
brush to put it in its lowest possible position. Make sure you still keep the sole of the floor
brush in contact with the surface you want to clean.
 With the delivered 2 in 1 accessory (Fig. 6) you can clean surfaces that are hard to reach,
such as furniture (use the crevice tool) and delicate surfaces such as curtains (use the
small brush). This accessory can be mounted on the handle or on the tube.
 After use we advise you to empty the dust collector to avoid smells and mildew that could
be caused by damp dust particles that could have been vacuumed, and also to
guarantee an optimal efficiency during the next use. To do so, press the release button (B)
and remove the dust collector (Fig. 7). Then hold it above the dust bin, and remove the
main filter.
WHEN CLEANING IS FINISHED
 Stop the vacuum cleaner by depressing on the switch button.
 Disconnect plug from electrical outlet.
 Simply press lightly with your foot on cable rewind button on top of cleaner. If the cord
does not enter completely in the appliance, pull 50 cm of the power cord out of the
appliance and try again.
FILTERS
To reach the filters situated in the durst collector, press the release button (B) and remove the
dust collector (Fig. 7). For practical reasons, it is recommended to remove the hose from the
connection inlet first.
The filter system consists of:
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
10
Assembly page 10/32
special instruction from
TEAM ST 6 E - 060105
Team