Practical Hints - Team ST 6 E Gebrauchsanleitung

Fax +32 2 359 95 50

 a main filter that stops the particles and allows the storage in the dust collector. This
filter plays the same role as a regular dust bag. This filter consists of 2 parts, a hard
bracket and a textile part fixed on an elastomer seam. To replace a dirty filter,
separate the bracket from this textile part by pulling at the elastomer seam and put a
new filter in the bracket by inserting it in the edge of the seam.
 a motor protection filter which catches larger particles in case the main filter wouldn't
have caught them. This filter is an additional protection for the motor but must not be
used as the only filter.
 an air filter situated in the air outlet grid (E) and filtering small particles rejected by the
motor.
Changing and cleaning the filters
A) Main filter
If you notice a loss of suction power, this means that the filter is full and must be replaced. The
replacing frequency depends both on the operation frequency and on the type of dust you
vacuum. For instance very small particles of plaster or concrete will stick to the filter very easily.
To reduce the replacing frequency, you can either remove the bigger particles obstructing the
filter, or shake the filter above the dustbin. Never try to clean the filter with a brush or water.
Filters are available at your retailer's.
B) Motor protection filter
Theoretically this filter must not be replaced, as the main filter catches almost all the
vacuumed dust particles, but if it is dirty, you can clean it. To do so, take it out of the appliance
and wipe it. You can also make use of some soapy water, but make sure it is completely dry
before putting it back in the appliance.
C) Air filter
 This filter guarantees fresh air during cleaning. It should be rinsed clean at least three times
a year or when it becomes visibly solid.
 Unplug the appliance, open the air outlet grille and remove the filter. Replace it and close
the grille.
D) Dust collector
Clean the inside of the dust collector with a damp cloth or sponge, but make sure it is totally
dry before using the appliance again.

PRACTICAL HINTS


When cleaning stairs, we advise you to keep the unit in a vertical orientation or to use the
shoulder strap provided. To attach it, fix its two rings in the loops on the appliance and pass
it along the end of the flexible hose before fixing the latter to the dust compartment.

There is a tube park at the back of the appliance. To attach the tube to the tube park,
put the appliance in vertical position.

In horizontal position, the appliance also has a storage facility in the back of the
appliance, that allows storing the floor brush, tubes and flexible hose (for instance to move
furniture).
If you notice a loss of suction power, it is probably due to one or a combination of the following
events: blocked filter, full or punctured bag or blockage in tubes. If your appliance still does not
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
11
Assembly page 11/32
special instruction from
TEAM ST 6 E - 060105
Team