Assembling The Vacuum Cleaner; Operation - Team ST 15 ET Handbuch


Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
Using the appliance when not all the filters are installed properly and in good shape might
damage the appliance. No guarantee claims will be accepted for damages due to that
reason.

ASSEMBLING THE VACUUM CLEANER

 Remove all packaging material from the appliance and its accessories.
 Insert the nozzle of the flexible hose (4) into the hose connection inlet on the front part of
the appliance. Press until it clicks (Fig 1). To remove the flexible hose, press on the release
button of the connection piece and pull it out of the appliance.
 Fit the telescopic tube (2) to the handle of the flexible hose (Fig. 2).
 You can adjust the length of the telescopic tube by pressing the button (5) situated in the
middle of the tube. (Fig. 3)
 Fit the other end of the telescopic tube to the suction device (1) or any other accessory
(Fig. 4).
 The 2-settings suction device allows you to clean all surfaces very easily, smooth surfaces
or carpets, simply by changing the brush position:
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.

OPERATION

 Make sure that filters are installed correctly. Using the vacuum cleaner without filters or
with filters wrongly installed could damage the appliance engine (cf paragraph "FILTERS")
 WARNING: In order to avoid electric disturbances when starting the appliance, it is
equipped with a "soft start" system. This prevents the engine from starting with too much
power, and for this reason, there can be a small interval (1 to 2 seconds) between pressing
the "start" button and the starting of the engine. This is perfectly normal.
 Once the appliance is assembled, pull out the cord to have the desired cord length. A
yellow mark indicates that you unwound nearly the whole cord length. The red mark is the
maximum limit above which you should not go. Plug the appliance in. Start the engine by
softly pressing the "ON/OFF" switch (8).
 You can adjust the suction power manually with the wind force adjuster (6) situated on
the hose handle, or with the electronic power control switch (7). Use a low suction power
for furniture and other delicate surfaces and use high suction power for fitted carpet and
other floors.
 A combined accessory (15) is provided to clean unreachable surfaces (narrow inlet) or
fragile surfaces such as furniture or curtains (long hair inlet). This accessory is fixed either to
the handle or to the extremity of the hose.
 The brush (14) is recommended for mattresses, stuffed furniture, sofas, tapestries.
 A place is foreseen at the back of the appliance to put every accessory.
AFTER USE
Stop the vacuum cleaner by pressing the ON/OFF switch (8).
 Unplug the appliance from the power supply.
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must be reproduced and folded in order to
obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). The
pages must be folded in order to keep the good numbering
when you turn the pages of the I/B . Don‟t change the page
numbering. Keep the language integrity
13
Assembly page 13/39
.
TEAM ST 15 ET - 070615