Assembling The Vacuum Cleaner - Team ST 10 E Gebrauchsanleitung

Fax +32 2 359 95 50


ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!
 Insert the hose connector into hose connection inlet until it locks (fig. 1). To remove the
hose, press the sides of the hose connector and pull at the hose.
 When removing hose assembly, pull out hose connection wand with pushing down two
connection buttons.
 Fit the tube to the handle (Fig. 2).
 Fit the tube to the floor brush (Fig. 3).
 Removing telescopic tube and accessories: to remove the accessories, pull firmly apart.
 The floor brush is ideal for the daily cleaning of carpets and hard floors.
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.
The appliance is delivered with the following accessories:

OPERATIONS
 Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark. Switch on the appliance by pressing the ON/OFF switch with your
foot.
 It is advisable to set the electronic power regulator to MIN before switching on the
appliance. By turning the regulator button, the suction power can be adjusted. You can
also adjust the suction power by using the wind-force adjuster on the handle (Fig 4). Use a
low suction power for furniture and other delicate surfaces and use high suction power for
fitted carpet and other floors.
AFTER USE
 Stop the vacuum cleaner by pressing the ON/OFF switch.
 Unplug the appliance from the power supply.
 Simply press the cable rewind button to activate the cable rewind mechanism.
REPLACING THE DUST BAG AND CLEANING THE FILTERS
Filters
The filter system consists of: 1 motor filter (in front of the motor in the dust compartment)
It is necessary to clean the filters regularly to avoid operating problems.
Paper dust bag
 The dust bag level indicator indicates when the dust bag should be replaced.
 The hose might get blocked by a larger object. In this case the dust bag level indicator will
be red. However this does not mean that you have to replace the dust bag. Just remove
the object, which blocks your tube or flexible hose, and your appliance will function
properly again. Do not forget to unplug the appliance before removing the blocking
object. Replace the dust bag when the dust bag level indicator is completely red.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
a crevice tool: for radiators, crevices, corners, baseboards

and between cushions.
an upholstery brush: for curtains, cushions, edges, doors,

mattresses etc.
1 air filter, to vacuum the smallest particles (on top of the motor in
the dust compartment)
9
Assembly page 9/28
special instruction from
TEAM ST 10 E - 060314
Team