Operation - Team ST 12 Gebrauchsanleitung

Fax +32 2 359 95 50

ASSEMBLING THE VACUUM CLEANER
 Always remove the plug from the power socket before fitting or removing accessories!
 Insert the hose connector into the hose connection inlet and turn it clockwise until it locks.
To remove the hose, turn the hose connector anticlockwise and pull at the hose
connector.
 Fit the tube to the handle.
 Fit the tube to the floor brush.
 Removing tube and accessories: to remove the accessories, pull firmly apart.
 The floor brush is ideal for the daily cleaning of carpets and hard floors.
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.

OPERATION

 Unroll a sufficient length of power cord and insert the plug into the power socket. Switch
on the appliance by pressing the ON/OFF switch with your foot.
 You can adjust the suction power by using the wind-force adjuster on the handle. Use a
low suction power for furniture and other delicate surfaces and use high suction power for
fitted carpet and other floors.
AFTER USE
 Stop the vacuum cleaner by pressing the ON/OFF switch.
 Unplug the appliance from the power supply.
 Roll the power cord around the cord storage facility at the back of the appliance.
 The carrying handle can be used to move the appliance. Never use the handle of the
dust container to carry the appliance!
 After use we advise you to empty the dust collector to avoid smells and mildew that could
be caused by damp dust particles that may have been vacuumed, and also to
guarantee an optimal efficiency during the next use. To do so, see below.
EMPTYING THE DUST COLLECTOR
 Press the release button of the dust container and pull the dust container out.
 Remove the lid of the dust container and spill the rubbish.
 Turn the lid back on the dust collector and put the dust collector back in the appliance
until it locks in place.
CLEANING THE FILTERS
Filters
The filter system consists of: 1 accordion filter to vacuum the smallest particles (in the dust
It is necessary to clean the filters regularly to avoid operating problems.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
container)
1 nylon filter (around the accordion filter)
8
Assembly page 8/36
special instruction from
TEAM ST 12 - 091123
Team