Turning The Power On/Off; Turn The Power On - Sony StorStation LIB-81 Gebrauchsanweisung

Turning the Power On/
Off

Turn the Power On

Turn on the AIT library power, then turn on the host
computer power.
1
Press the power switch on the rear of the library.
The following message appears and the startup
process begins. (Startup takes several minutes.)
LIB-81
Initializing
When the startup process ends, the library enters
the time setting mode.
Jan/01/2001
[ENTER] to set the
Date and Time
[CANCEL] to exit
Caution
Models equipped with a bar code reader
By default, the library is not set to read bar codes. If you
modify this setting so that the library can read bar codes
and use cartridges without bar code labels, initialization
after turning on the library takes unusually long. For
details about how to set the library to read bar codes,
refer to "Setting the Bar Code" in Chapter 3 of the
"Operating Instructions" (PDF).
Models without a bar code reader
Modifying the default setting so that the library can read
bar codes generates an error. You should not modify this
setting.
14

Turning the Power On/Off

12:00:00
2
If you want to change the date and time, press the
[ENTER] button. If you do not want to make
changes, press the [CANCEL] button.
For details about the date and time settings, refer to
"Setting the Date and Time" in Chapter 2 of the
"Operating Instructions" (PDF).
Once the library is started, the status display below
appears.
READY
1
AIT3 5
Notes
• The date and time cannot be updated when the AIT
library is off. For this reason we recommend that you
set the date and time each time you turn on the library.
• If the library is left idle for five minutes, the status
display appears automatically.
3
After pressing the power switch on the rear of the
library, wait at least 10 seconds before turning on
the host computer.
When using DHCP, wait at least 30 seconds.
Then refer to "Initial Setup" in Chapter 2 of the
"Operating Instructions" (PDF).
Notes
• If you start the host computer before the library, the
SCSI ID is not detected correctly. Therefore, always
start the library before starting the host computer.
• If the library does not work as above, refer to
"Troubleshooting" in the "Appendix" of the
"Operating Instructions" (PDF).
Turn the Power Off
Before turning off the library, perform the system
shutdown procedure from the control panel. After you
have performed the procedure, you can turn off the
library.
1
At the status display, press the [MENU] button for
two seconds.
2
Use the V and v buttons to select "9. System
Down," then press the [ENTER] button.
Menu
7.Tape Inventory
8.Password
9.System Down
2 3 4
6 7 8
12:34