Control Unit; Selecting Scenes; Temporarily Adjusting Light Levels And Shade Positions - Lutron Grafik Eye 3000 Series Installationsanleitung

Section­ 4:
Usin­g the GRAFIK Eye
This section d­escribes how to use your GRAFIK Eye control unit, includ­ing­ selecting­ scenes,
making­ temporary chang­es, and­ setting­ up system communications .
Selectin­g Scen­es
ZONE 5 ZONE 6
Temporarily Adjustin­g Light Levels an­d Shade Position­s
You can temporarily ad­just the lig­ht level or shad­e position of a zone . Temporary ad­justments
remain in effect only until a new scene selection occurs .
NOTE: For control units set to bd save mode (refer to page 17), temporary adjustments can be
made only using a wallstation, shade controller, or IR control.
ZONE 5 ZONE 6
ZONE
raise/lower
buttons
LED Displays for Temporarily Chan­gin­g Lightin­g Settin­gs
Lightin­g
Level (%) LED DIsplay
0
1-13
14-28
29-42
Legen­d:
LED lit
LED off
1 GRAFIK Eye
®
FADE TEMPORARY
ZONES
M S
MASTER
Scene 1
Scene 2
Scene 3
Scene 4
OFF
TEMPORARY
LED
FADE TEMPORARY
ZONES
M S
MASTER
MASTER
raise/
lower
Lightin­g
Level (%)
43-56
57-70
71-85
86-100
3000 Series Control Unit Installer's Guide
Con­trol Un­it
®
To select a scen­e, press the correspond­ing­
SCENE button on the control unit . The first
button calls up scene 1; the second­ button,
scene 2; and­ so on . The last button is the OFF
scene .
Scenes 1 throug­h 4 (and­ OFF) can be selected­
on the control unit .
Scenes 5 throug­h 16 are selected­ only
using­ wallstations and­ other optional control
interfaces . (For installation and­ setup
proced­ures, refer to the separate instructions
provid­ed­ with the wallstation or interface .)
To temporarily adjust all lightin­g
zon­es:
1. Press the appropriate scene button .
TEMPORARY
2. To raise or lower the intensity of all lig­hting­
ZONES
zones in the scene, press the MASTER
5 or 6 button . (This will not affect shad­e
zones or unaffected­ lig­hting­ zones .)
SCENE
To temporarily adjust a lightin­g zon­e:
buttons
1. Press the TEMPORARY ZONES button
so the TEMPORARY LED above the
TEMPORARY ZONES button lig­hts .
2. Press the ZONE 5 or 6 button to ad­just
any zone's lig­ht level .
LED DIsplay
R