Tylo Prime+ 1515/C Benutzerhandbuch Seite 8

Short bench ( 2):
Box
• Rest the bench upright against the back wall panel.
• Connect the S-2 electrical supply to the S-2 junction box.
• Fix the cover of the S-2 junction box with 2 Phillips screws.
Lay the bench down and push first the right hand and then the left hand edge into position.
•
• Push the seat onto the back wall panel.
Front wall panel:
• Place the left hand glass section into the floor slot and the slot in the left hand wooden panel.
• Note: The long loop on the seal should be on the inside of the two fixed panels.
• Place the right hand glass section into the floor slot and the slot in the right hand wooden panel.
Page 8