Thermalright TRUE Spirit 140 Direct Bedienungsanleitung Seite 10

Installation Instructions:
Step 1:
Step 1 : Screw Pillar Installation
Take out TS-140 Direct heat-sink from the color box . Pull both ends of the Fan clip and make
them go through holes on the corners of the heat-sink. (As shown in the picture.) Repeat for the
other fan clip. Leave both fan clips on the heat-sink body for fan installation later on . Insert the
four black Rubber Tubes (Noise damping use) into the four indents on the front of the heat-sink
body. Do not remove them.
Step 2:
Step 2 : Screw Pillar Installation
Place the motherboard (the processor installed) on top of the desk or a workbench. Fix the four included
LGA2011 Type B Screw Pillars into the heat-sink studs on the Intel ILM Assembly Frame around the
processor socket in a criss-cross pattern.
Step 3:
Step 3 : Anchoring Mount Installation
Place the Anchoring Mount on the Screw Pillars. Use the four M3L6 Screws to fix the Anchoring Mount
on to the Screw Pillars, also in a criss-cross pattern to ensure balanced mounting.
7
4
1
3
4
1 2
3
2