English; Getting Started - Electrolux ESB29 Serie Gebrauchsanweisung

ENGLISH

Thank you for choosing an Electrolux product. In order to ensure the best results, always use original Electrolux
accessories and spare parts. They have been designed especially for your product. This product is designed with
the environment in mind. All plastic parts are marked for recycling purposes.
COMPONENTS
A. Spill-proof drinking lid with carry handle
B. Blend bottle
C. Blender blade assembly
D. Speed selector
E. Blender base
F. Power cord
G. Mini bottle/grinder jar*
H. Grinder blade assembly*
Picture pages 2-3

GETTING STARTED

1
Before fi rst use: Clean the blender according to the instructions in "Cleaning and Care". Fill the bottle with
ingredients.
Caution! Do not exceed the maximum fi lling volume: 600 ml for the blend bottle (B) and 300 ml for the mini
bottle/grinder jar (G). Do not mix dough, mashed potatoes, meat etc.
2
Fill the ingredients in either bottle. Fasten the blender blade assembly (C) on the open end of the bottle by
turning it clockwise.
Caution! The blades and inserts are very sharp!
3
Place the blender base on a fl at, level surface. Plug into a power outlet.
4
Turn the bottle upside down. Push down the bottle into the blender base (E) and rotate it clockwise to lock.
Note: When locked, the symbol
blender base.
Caution! To reduce risk of injury, never place the blade assembly on the base without the bottle properly
attached.
5 Turn the speed selector (D) to 1 or 2 according to the recipe/preference. Turn the speed selector to "PULSE" for
short bursts of power.
Caution! If the motor stalls, turn the blender off immediately, unplug the appliance and let it cool for at least 10
minutes.
6
When the ingredients are fully mixed: Turn the speed selector to "OFF" to stop mixing. Make sure the motor has
stopped completely, then press the bottle down and turn it counter-clockwise to release it. Remove the bottle
from the blender base and turn it upside down. Replace the blade assembly with the drinking lid (A).
USING THE COOLING STICK*
The cooling stick cools down and maintains the temperature of your freshly prepared blends.
7
Unscrew the cap (J) of the cooling stick (I) and fi ll it with tap water until the MAX mark. Screw the cap back on
the cooling stick and place it in the freezer until the water freezes.
8
Screw the frozen cooling stick on the drinking lid with carry handle (A). Attach it on the blend bottle (B). The
cooling stick can be cleaned in a dishwasher.
Note! The cooling stick does not fi t the mini bottle (G).
USING THE GRINDER*
9 Fill the ingredients in the mini bottle/grinder jar (G). Fasten the grinder blade assembly (H) on the open end of
the bottle by turning it clockwise.
Caution! The blades and inserts are very sharp!
10
Turn the bottle upside down. Push down the bottle into the blender base (E) and rotate it clockwise to lock.
Note: When locked, the symbol
blender base.
Caution! To reduce risk of injury, never place the blade assembly on the base without the bottle properly
attached.
www.electrolux.com
ESB29xx_Sportblender_Electrolux NO-FARSI CS6.indd 6 ESB29xx_Sportblender_Electrolux NO-FARSI CS6.indd 6
I. Cooling stick*
J. Cooling stick cap*
K. Chopper base*
L. Chopper base shaft*
M. Chopper blades *
N. Chopper jar*
* Certain models only
on the blender blade assembly should be aligned with the symbol on the
on the grinder blade assembly should be aligned with the symbol on the
6
21.07.17 17:21 21.07.17 17:21