Installing The Unit; Installation Procedure Save Vtc 700 - SystemAir SAVE VTC 700 Betriebs- Und Wartungsanleitung

12
| Installation
5.3

Installing the unit

The unit must be installed in the following position (figure 2). It is important
that the unit is completely level in order for the condensation drainage to
work properly.
5.3.1

Installation procedure SAVE VTC 700

1 Prepare the surface where the unit will be mounted. Make sure that the
surface is flat, levelled and that it supports the weight of the unit. Perform
the installation in accordance with local rules and regulations.
2 Place the unit standing on the floor. Use the enclosed adjustable feet to
level the unit
Warning
Beware of sharp edges during mounting and maintenance.
Use protective gloves
3 Connect the condensate drainage to the 2 drain plugs in the bottom of
the unit. Make sure to use correct drain traps on both connections. The
height (H) must be at least 60 mm. Drain traps are not included on deliv-
ery and can not be obtained from Systemair.
4 Connect the unit to the duct system. Make sure that all necessary acces-
sories are used to create a functional ventilation solution.
Important
The installation of the unit and complete ventilation system
must be performed by an authorized installer and in
accordance with local rules and regulations.
5 Connect the control panel to the socket in the connection box on top of
the unit.
6 Connect the unit electrically to the mains with the enclosed plug and
check that it starts up correctly.
C
D
B
A
Fig. 2 Installation position (right
hand unit)
211467 | A004
GB