Abilica 820 Rower Bedienungsanleitung Seite 24

LOAD ADJUSTMENT
ASSEMBLY INSTRUCTIONS
The resistance of the shock can be adjusted by twisting
the adjustment knob at the top of the shock. There are
settings from 1 to 12. Setting 1 will provide the lowest
resistance. Setting 12 will provide the highest resistance.
Caution: HOT
The shock get after a few minutes of use.
ROPE ADJUSTMENT
Over time your ROPE(51) may stretch. If the ROPE(51) doesn't retract fully into the
UPRIGHT(3) and the HANDLEBAR(9) doesn't stay on the HANDLEBAR HOLDER(50),
make this adjustment. Remove the HANDLEBAR COVER(52) by unscrewing the
SCREWS(M4x15mm)(49). Loosen the BOLTS(M6x1x20mm) (64), but do not remove them. Pull
the ROPE(51) until there is a 3/8 inch of gap on the shaft of the SHOCK(42), refer to illustration A.
Then entwine the ROPE(51) around the BOLTS(M6x1x20mm)(64) using a figure eight pattern
and tighten the bolts so the ARC WASHERS(M6)(65) press against and secure the
ROPE(51) in position. Re-attach the HANDLEBAR COVER(52) with the
SCREWS(M4x15mm)(49).
24