Troubleshooting - Geemarc Amplicall 10 Handbuch

Trouble shooting
Symptom
No incoming call yet the
Amplicall10 rings
automatically or rings
continuously; the shaker
vibrates automatically or
continuously; the strobe
LED flashes automatically.
The red low battery LED
flashes automatically.
When there is an incoming
call but no ringing can be
heard.
When there is an incoming
call but the shaker doesn't
vibrate.
INSTALLATION
Solution
1) Check the batteries are
inserted correctly.
2) Check the power adaptor
is connected correctly.
3) Turn off the power switch
for 10 minutes and then
turn it on.
1) Replace the batteries.
2) Turn off the power switch
for 10 minutes and then
turn it on.
1) Check it is connected to
the power adaptor
correctly;
2) Check the batteries are
installed correctly.
3) Check if the volume switch
is switched on.
4) Check it is connected to
the line cord correctly.
1) Check it is connected to
the shaker correctly.
2) Check the shaker socket to
see if it has been
damaged.
3) Check the alarm mode
selection switch position is
correct.
6