Performing The Inhalation; Completing The Inhalation - Pari SINUS Gebrauchsanweisung

3.3 Performing the inhalation

To avoid overheating the compressor, never place a cover over the
To avoid overheating ...
device during operation, and ensure that the side ventilation slits are
not obstructed. If the compressor is covered or if the ventilation slits
are blocked, the compressor cannot be cooled properly.
• Before starting the treatment, pull the nebuliser out of the
holder.
• Start the compressor by pressing
the on/off switch.
• Check that an aerosol is being
generated before you start with the
inhalation.
In the event of ...
WARNING
In the event of damage to the device a person may come into
contact with live parts, and there may be a risk of electric
shock. Therefore, switch the compressor off and disconnect the
power plug from the mains socket immediately if the compressor
or the power cord is damaged or if damage is suspected (e.g.,
following a fall or if there is a smell of burning plastic).
• Perform the inhalation as described in the instructions for use
of the nebuliser.

3.4 Completing the inhalation

• Switch the compressor off.
• Place the nebuliser back in its holder.
• Disconnect the power plug from the mains socket.
Complete disconnection ...2
Complete disconnection from the mains is only certain when
the power plug has been unplugged from the socket.
- 43 -
en