Using The Compressor - Pari SINUS Gebrauchsanweisung

1.4 Using the compressor

The compressor is an electrical device that is powered by supply
voltage. It has been designed so that no live parts are
accessible. However, if ambient conditions are unfavourable or
if the compressor or power cord is damaged, this protection may
no longer be assured. Therefore, please follow the instructions
below to avoid damage to the device and the associated danger
of contact with live parts (e.g., electric shock):
– The compressor is not splashproof. Protect the device and the
power cord from liquid and moisture. Never handle the device,
the power cord or the power plug with damp hands. In
addition, the device must not be operated in a damp
environment.
– Only use the PARI power cord to operate the compressor.
– Never leave the compressor unattended while it is in use.
– For safety reasons, always disconnect the power plug from the
socket under the following circumstances:
- if a malfunction occurs during operation
- before cleaning and maintaining the device
- immediately after use
– Always pull the power plug, not the cable, to disconnect the
power cord from the socket.
– Make sure that the power cord is never kinked, pinched or
jammed. Do not pull the power cord over sharp edges.
– Keep the compressor and the power cord away from hot
surfaces (e.g., stove top, electric fire, open fire). Direct heat
may damage the compressor housing or the power cord
insulation.
– Keep the power cord away from domestic animals (e.g.,
rodents). They may damage the power cord insulation.
- 34 -