Securing Your Child In The Babysafe Westie - BabySafe Westie Instruction

SECURING YOUR CHILD IN THE BABYSAFE WESTIE

CAUTION!
Check that the BabySafe Westie is mounted properly and that all belts have proper
tension, also that all locking mechanisms are secured and all safety displays show
GREEN.
Adjusting the central device
At the front of the seat under the cover there is the
central adjusting device, which clamps the central
harness tight. Loosen the central adjusting device
by pushing the cap of the central adjusting device
up and pull the harness forward (do not pull on the
harness cushion).
Adjusting the headrest.
To adjust the headrest by pulling the handle on
the top. It should be set the right position, this me-
ans that the shoulder harness should
come out approximately 1 cm above the child's
shoulder.
Placing your child in the seat.
- Open the harness buckle by pushing the re d button, and parting the buckle
tongue to the sides.
- Place your child as far back into the seat as possible, bring the shoulder/lap har-
ness and central harness in the front of the child and match the tongue first, then
insert into main body of the buckle.
- Pull the central harness on the adjusting device to make sure the harness secures
your child at proper tightness, by checking with your two fingers gap between
harness and your child's front shoulder point. Make sure your child is comfortable
and secured.
14
Checking Point.
- Check that the buckle is fully closed, and none of the harness straps are twisted.
- Check that the headrest must be adjusted to the size of the child at proper po-
sition for child's head.
- Check that the shoulder pad should be located slightly above the child's shoul-
der. The shoulder harness should lie in the middle between the child's neck and
the outer edge of the shoulder.
15