Start-Up - GOK SmartBox 1 Montage- Und Bedienungsanleitung

Excess voltage!
Damage to components and device defect.
No 230 V AC connections may be made to terminals 3 + 4 or probe input terminals 1 + 2!

START-UP

Operation elements and display
The device is adjusted once when it is put into operation. After start-up the device operates in
display mode with the top closed.
The display is a two-line LCD display with 2 x 16 characters.
The display has blue background lighting for best readability in all lighting conditions.
Activating power supply:
Keep away from the area of the 230 V terminal!
®
SmartBox 1, 2 and 3 has the following display:
Heat oil
-10.100L
After the level indicator has been installed, it can be started up. Before PROGRAMMING, you
need to ascertain the tank data and enter the values into the right column input value of the
following table. Then, enter the values for the individual entry steps.
Setting a
parameter:
Quitting the
setup mode:
part no. 28 100 57 f
37.400L
75%
Press [ENTER] to open setup mode.
Select the desired setting parameter via [PLUS].
Press [ENTER] to call up the value selection for the parameter.
Set the value with [MINUS]/[PLUS], press [ENTER] to save.
You can quit the setup mode at any time.
Select "Exit" and press [ENTER]
 to go back to the standard display mode.
®
SmartBox 1 / SmartBox
The device is adjusted via the three small
blue buttons:
Select the language (German, English or
French) in menu step 18.Language.
®
2 / SmartBox
These are located on the
motherboard between the
terminals.
®
3
7 / 20