Bosch DCU 220 Instandsetzungsanleitung Seite 24

4.3.2 Loading recovery image to hard disk
i
The size of the recovery image is approx. 10 GB. The
download can therefore take some time to complete,
depending on the Internet connection.
1. Open the download portal DCU 220 via:
http://cdn.esitronic.de/TED/DCU220/Recovery_DCU220.html
2. Download the "Recovery-Image G3".
3. Connect the bootable hard disk.
4. Copy the WIM file into the first"Recovery" folder on
the bootable hard disk.
"
Image is now available on the hard disk and can be
used for the installation.
i
As long as there is no new software version of the
Disk Boot Maker available, a new image can be loa-
ded by replacing the old WIM file on the hard disk.
4.3.3 Installing current image from hard disk
!
All data and applications on the hard disk will be
erased during the installation!
!
Make sure the voltage supply is not interrupted du-
ring the installation process.
1. Connect the bootable hard disk to DCU 220.
2. Switch on the DCU 220.
3. If the following screen appears during the system
start, press <F10>.
 The Options menu opens:
4. Select Boot Manager.
Robert Bosch GmbH
5. Select the bootable hard disk as boot device from
the displayed screen.
 The software starts after a few seconds.
Name Function
Replaces the existing recovery version of
the recovery partition with the recovery ver-
Option 1
sion on the connected hard disk. If no re-
Only Recovery
covery version is installed, the recovery
partition
version of teh coneected hard disk will be
installed.
6. Select <Start> under the option Recovery Partition.
 The recovery partition is replaced by the recovery
version on the connected hard disk.
7. Continue with chapter
| DCU 220 | 9
4.4 step 4.
|
1 689 975 287 2017-07-06
de