Compatible Devices; Charging External Devices - Silvercrest SLS 2200 C2 Bedienungsanleitung

Compatible devices

You can use the solar charger to charge end devices that require
a charging current of at least 60 mA and a maximum of 1 A.
If the connected end device requires a current of less than 60 mA
or more than 1 A, the solar charger will switch itself off immedi-
ately after being switched on with the ON/OFF button
case, check the charger's suitability for your end device on the
basis of the technical data of your end device.

Charging external devices

Connect the charging cable of your end device to the USB port
on the solar charger and to your end device.
♦ If charging does not start automatically, press the ON/OFF
button briefly to start the charging process.
The LED
is being charged. Once your device is fully charged, the solar
charger switches off. To interrupt the charging process, you can
disconnect the end device. If your end device is not fully charged
and the LED
charger's battery is discharged. The solar charger's battery must
be recharged again before you can charge end devices.
Simultaneous charging of the built-in battery and a connected
device is only possible in solar operation. Simultaneous charging
of the built-in battery via the micro-USB port
device is not possible.
│
■ 74 GB
lights up for as long as the connected device
goes out during charging, this means the solar
. In this
and a connected
SLS 2200 C2