Limitations Of Use / Security - TEUFELBERGER tripleA Herstellerinformation Und Gebrauchsanleitung

LIMITATIONS OF USE / SECURITY

Attaching the "easyAccess"
connector (not included with the product, available
as an accessory). The "easyAccess" connector
is attached to the harness with the 25 mm Cobra
buckle (one part is sewn into the harness - Fig. 17,
one part is sewn into the connector) - Caution,
Please follow the safety notes of the connector's
manufacturer and ensure that both buckle parts are
properly closed (locked)!
Attachment loops for seat board
To attach a seat board (not included with the pro-
duct, available as an acessory) Caution: Please
follow the safety notes of the seat board's manuf-
acturer.
4. How to put on the harness correctly:
� Open the Cobra buckles (shoulder strap and leg
straps)
� Step into the sub-pelvic belt with both legs
� Fasten the sub-pelvic belt (by simultaneously
pulling both straps left and right on the sub-
pelvic belt)
� Adjust the leg loops, waist belts and shoulder
12
Abb. 16
Abb. 17
Abb. 18
straps (it should be possible to put a flat hand
between the belt and the body), the fall arrest
eyelets (designated "A") in front of the breast
bone, the holding eyelets at the front center
and/or laterally at the waist belt..
� Adjust the lateral elastic straps (lateral connec-
tions between the front fall arrest eyelet to the
waist belt) - should be stretched just loosely
5. How to select an anchor point:
According to EN 795, the anchor point (anchor de-
vice) for personal protective equipment against falls
from a height must be able to withstand a force of
12 kN and meet the requirements specified in the
user's guide of the fall protection system used. The
anchor point should always be located above the
user.
The connection between the harness and anchor
point must be suitable for the standard covering the
respective type of use and must have been certified
to it.
� Fall arrest system (e.g., energy absorber to
EN 355, guided type fall arresters to EN 353-
1/2, retractable type fall arresters to EN 360)
� Restraint system (e.g., lanyards to EN 354 or
EN 358)
� Work positioning system (e.g., lanyards to
EN 354 or EN 358)
� Rope access system (e.g., rope adjustment
device to EN 12841, rope to EN 1891)
It is crucial to safety to select the position of the
anchor point and the way how the work is done
such that the free fall and the height of a fall are
restricted to a minimum. It is crucial to safety to
ensure prior to any work assignment that there is
enough free space at the work site under the user
(prevention of an impact on the ground or on an
obstacle).
Only a fall arrest harness may be used as the
body holding device in a fall arrest system.
Lanyards must not be placed across sharp edges!
Pendulum motions during falls must be avoided
by selecting a suitable anchor point.
LIMITATIONS OF USE
Never carry out work with this product if, as a result