TEUFELBERGER tripleA Herstellerinformation Und Gebrauchsanleitung Seite 10

USE
EN 361: These harnesses are mainly used for fall
arrest purposes, i.e., they support the
entire body of the wearer and, in the
event of a fall and after arresting a fall,
hold him/her in an upright position.
CAUTION! Use is permitted only in com-
ination with waist belt & shoulder straps.
EN 358: This harness belays its wearer at the work
site (work positioning) or prevents the
wearer from reaching a location from
where he/she can fall down (restraint
function).
A work positioning harness to EN 358
by itself is not suitable for fall arrest
purposes!
In order to provide protection against falls
from a height, it may be necessary to use
configurations including collective
equipment (e.g., safety nets) or personal
protective equipment (e.g., fall protection
systems to EN 363)!
EN 813: This harness holds the body of the user,
who must be conscious, in a sitting posi-
tion.
A sit harness to EN 813 alone is not
suitable for fall protection purposes!
Rather, for protection against falls from a
height, it may also be necessary to use
configurations including collective equip-
ment such as safety nets, or personal
protective equipment such as fall protec-
tion systems to EN 363!
Prior to first use, users should perform a
hanging test in a safe location to verify
that the sit harness has the right size and
offers sufficient adjustment options and a
reasonable level of comfort for the
intended use
1. Selecting the right harness size:
Harness size:
tripleA Gr.1 / leg circumference 50 - 80 cm
waist circumfer 80 - 115 cm
Bodyheight to 185 cm
tripleA Gr.2 / leg circumference 50 - 95 cm
waist circumfer 80 - 140 cm
Bodyheight from 185 cm
Maximum nominal load: 140 kg
(= maximum weight of user incl. tools and gear)
CAUTION! When using these products in a fall pro-
tection system, it is imperative to observe the perti-
10
nent specifications contained in the manufacturer's
information for the products used!
2. Correct use of harness closure and readjust-
ment buckles: (buckle design depends on harness
type).
a) 3-bar buckle
Closing the buckle
Pic. 3
1. Insert the loose strap end together with the
insertion buckle through the O buckle from
below. (Pic. 3)
2. Align insertion buckle in parallel with O buckle.
(Pic 4)
Readjusting (Adapting) harness straps)
Pic. 5
1. Pull end of strap to tighten it. (Pic. 5)
2. Pull tongue to loosen it. (Pic 6)
b) SafeClick buckle
Pic. 7
Closing the buckle
Push the parts of the buckle together until you hear
a "CLICK" noise. Check proper locking/functioning
of the buckle (buckle halves freely movable inside
each other, gap between buckle halves 2-3 mm;
pulling at both buckle halves).
Pic. 4
Pic. 6