TEUFELBERGER tripleA Herstellerinformation Und Gebrauchsanleitung Seite 11

Opening the buckle
1. Push buckle halves together.
2. Simultaneously press both unlocking buttons
towards the TEUFELBERGER logo
3. Pull parts of the buckle apart.
3. Fall arrest and holding eyelets:
Fall arrest eyelets - EN 361
Holding- and Sit eyelets
Pic. 10:
Holding eyelets (EN 358) laterally
at the waist belt
Pic. 11
Sit eyelet (EN 813) front center at
the waist belt
On TEUFELBERGER fall arrest harnesses, the wa-
ist belts (depending on model and design) include
mounts for gear ("gear loops" - Pic. 12) and tool
bag mounts ("attachment rings" - Pic. 13).
Pic. 8
Fall arrest eyelet (EN 361)
in the area of the breast
(designated A)
Pic. 9
Fall arrest eyelet (EN 361)
in the area of the back
(designated A)
Abb. 12
They must not be used to belay persons and have
the following max. load carrying capacity (static):
Gear loop (Pic. 12):
25 kg max. per loop (e.g., to transport carabiners,
ascenders, aluminum pulleys)
Tool bag attachment ring (Pic. 13)
10 kg max. per ring (for attaching one tool bag to 2
rings each)
CAUTION! Falls can result in dynamic loads that
exceed these acceptable values (this requires ad-
ditional protection of the parts carried on them
against falling down or protection of the endangered
zones under the work site).
Attaching a chest-rope clamp
(not included with product, available as an accessory)
1. Attach the clamp on the lower round opening
using the triangular screw connector in the center of
the sub-pelvic strap (use a tool to tighten safety screw)
2. Afterwards, fasten the clamp on the harness using
the 20 mm strap band sewn into the harness af-
ter pulling it through the upper oval strap opening.
Please note: Follow manufacturer instructions for the
chest-rope clamp!
Abb. 14
Attaching a "first aid kit" on the harness
1. A "first aid kit" (not included with the product)
can be attached to the rear of the sub-pelvic strap
with the two 20 mm strap bands included with the
harness
USE
Abb. 13
Abb. 15
Brustklemme
11