Working Advice - Bosch GWS 14-125 Inox Professional Originalbetriebsanleitung

OBJ_BUCH-611-003.book Page 31 Monday, April 21, 2008 11:28 AM
Speed preselection
The required speed can be preselected with the thumbwheel 3 (also while running).
The data in the following table are recommended values.
Material Application
Metal Removing paint
Wood, metal Brushing, rust re-
moval
Metal, masonry Grinding
Metal Rough grinding
Masonry, stone Cutting

Working Advice

Exercise caution when cutting slots in
structural walls; see Section "Information
on Structures ".
Clamp the workpiece if it does not remain
stationary due to its own weight.
Do not strain the machine so heavily that it
comes to a standstill.
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Rough Grinding
Never use a cutting disc for roughing.
The best roughing results are achieved when
setting the machine at an angle of 30° to 40°.
Move the machine back and forth with moderate
pressure. In this manner, the workpiece will not
become too hot, does not discolour and no
grooves are formed.
Flap Disc
With the flap disc (accessory), curved surfaces
and profiles can be worked.
Flap discs have a considerably higher service
life, lower noise levels and lower sanding tem-
peratures than conventional sanding sheets.
Bosch Power Tools
Accessory
Sanding disc
Cup brush, sanding disc
Grinding disc
Grinding disc
Cutting disc and cutting guide
(Cutting masonry/stone is permit-
ted only with use of the cutting
guide)
Cutting Metal
For cutting metal, always work with the pro-
tection guard for cutting 13.
When cutting, work with moderate feed, adapt-
ed to the material being cut. Do not exert pres-
sure onto the cutting disc, tilt or oscillate the
machine.
Do not reduce the speed of running down cut-
ting discs by applying sideward pressure.
Cutting Stone
For cutting stone, always work with the cut-
ting guide with dust extraction protection
guard 20.
The machine may be used only for dry cut-
ting/grinding.
English | 31
Thumbwheel Position
1 – 3
3
4 – 6
6
6
The machine must
always work in an
up-grinding mo-
tion. Otherwise, the
danger exists of it
being pushed un-
controlled out of
the cut.
When cutting pro-
files and square
bar, it is best to
start at the smallest
cross section.
1 609 929 R00 | (21.4.08)