Herunterladen Inhalt Inhalt Diese Seite drucken

Operating Elements And Connections; Safety Notes - Monacor JTS US-902D/5 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

All operating elements and connections described
can be found on the fold-out page 3.

1 Operating Elements and Connections

1.1 Front panel
1 Operating and display panel for receiving unit 1
2 Operating and display panel for receiving unit 2
3 Power switch
4 Reception antennas
5 Volume controls, each for receiving unit 1 and
receiving unit 2
L
6 Keys "Up"
and "Down"
– for selecting the transmission channel, sepa -
rately for both receiving units
1. In the respective operating panel, press the
L
M
key
or
(for a minimum of 1 s): on the dis-
play the indication RX1 or RX2 (b) flashes.
2. As long as the indication keeps flashing (for
approx. 3 s after pressing a key), the channel
can be selected: With the key
are scanned in ascending order, with the key
M
, they are scanned in descending order.
– for activating/deactivating the lock mode for
both receiving units together
1. To activate the lock mode, in one of the oper -
ating panels, keep the keys
simultaneously until LOCK (a) is displayed: In
this case, the transmission channels cannot
be changed any more.
2. To deactivate the lock mode, in one of the
operating panels, keep the keys
pressed simultaneously until the insertion
LOCK disappears.
7 Multifunction LC display (see fig. 3)
– for both receiving units:
a insertion LOCK with activated lock mode: in
the lock mode it is not possible to change the
transmission channels adjusted for both
receiving units
– for receiving unit 1 and receiving unit 2 respec-
tively:
b indication RX1 (for receiving unit 1) or RX2
(for receiving unit 2): flashes when the chan-
nel adjusting mode has been activated for the
respective receiving unit
c indication RF for the receiving power of the
radio signal: the more segments are dis-
played, the better is the reception
d indication AF for the volume of the audio sig-
nal received [independent of the volume con-
trols (5)]: the more segments are displayed,
the higher the volume level
M
L
the channels
L
M
and
pressed
L
and
e reception indication
of the two antennas receives the more power-
ful radio signal
f indication of the transmission channel
g muting symbol: indicates that the respective
receiving unit has been muted because it
eith er receives a radio signal which is too
poor or no radio signal at all
1.2 Rear panel
8 Output of the master signal of the two receiving
units (6.3 mm jack, unbal.) for connection to a line
input of a mixer/amplifier
9 Power supply jack for connecting the power supply
unit
10 BNC jacks for connecting the antennas (4)
11 Balanced XLR outputs CH. 1 and CH. 2, respec-
tively for the output signal of receiving unit 1 and
the output signal of receiving unit 2, for connection
to two balanced microphone inputs of a mixer/
amplifier
12 Squelch controls CH. 1 and CH. 2, respectively for
receiving unit 1 and receiving unit 2, for adjusting
the threshold for the noise suppression

2 Safety Notes

The units (receiver and power supply unit) correspond
to all relevant directives of the EU and are therefore
marked with
.
WARNING The power supply unit is supplied with
hazardous mains voltage (230 V~).
Leave servicing to skilled personnel
only. Inexpert handling may cause an
M
electric shock hazard.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not operate the receiver and immediately dis-
connect the power supply unit from the mains socket
1. if there is visible damage to the units or to the
mains cable,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled per-
sonnel.
G
A damaged mains cable of the power supply unit
must be replaced by the manufacturer or skilled
personnel only.
G
Never pull the mains cable of the power supply unit
for disconnecting the mains plug from the socket,
always seize the plug.
or.
: indicates which
A
B
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis