Operating Elements And Connections - Monacor AV-200SET Bedienungsanleitung

Please unfold page 5. Then you can always see the
operating elements and connections described.
Contents
1

Operating Elements and Connections

1.1 Connections of the transmitter station
and the receiver station . . . . . . . . . . . . . . . . . 9
1.2 Lower side of the unit . . . . . . . . . . . . . . . . . . 9
2 Safety Notes . . . . . . . . . . . . . . . . . . . . . . . . 10
3 Applications . . . . . . . . . . . . . . . . . . . . . . . . 10
3.1 Conformity and Approval . . . . . . . . . . . . . . . 10
4 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . 10
4.1 Placing the transmitter station
and the receiver station . . . . . . . . . . . . . . . . 10
4.2 Setting the transmission channel . . . . . . . . 10
4.3 Connecting the units . . . . . . . . . . . . . . . . . . 11
4.4 Readjusting the audio and video levels . . . . 11
5 Specifications . . . . . . . . . . . . . . . . . . . . . . 11
1 Operating Elements and Connections
1.1 Connections of the transmitter station and
the receiver station
1 Antenna (do not scratch or break off)
2 Power LED, on the transmitter station only
3 DIN AV jack, pin configuration (fig. 2):
1 —
2 video signal, 1 Vpp
3 ground
4 audio, left
5 on the receiver station only: output of control
voltage +5 V, max. 80 mA for additional units,
e. g. RF modulator
6 audio, right (for stereo only)
4 Low voltage jack for power supply
the transmitter requires 12 V /150 mA,
the receiver requires 8 – 10 V /320 mA;
centre contact = positive pole
required low voltage plug 5.5/2.1 mm (outside/in-
side diameter)
1.2 Lower side of the unit
5 Trimming control
on the receiver for readjusting the video level if
the picture on the reproduction unit (e. g. TV set,
surveillance monitor) is too bright or too dark
on the transmitter for readjusting the audio level
if the sound transmission is too low or distorted
6 Selector switch for the transmission channel;
factory-set to channel 1
9