Panasonic WV-Q126A Installationsanleitung Seite 9

Turn this bracket sideways as shown in the
e
following drawing, and attach the paper
gauge to the camera mounting stage.
Attach the paper gauge so that it passes
through the slit shown in the following draw-
ing.
Paper gauge attaching position
b Attach the
paper gauge
Step 5
Pass the cables from the ceiling through the
q
loop of the tie wrap attached to the mount
bracket in advance. Tie wraps used for
passing the cables vary with models. The
cable passing position is in the following
drawing.
Models with use of camera mount bracket
(accessory to the camera): tie wrap A or tie
wrap C in the following drawing
Models with use of base unit (component
of the camera): tie wrap B or tie wrap D in
the following drawing
Paper gauge
Slit
Tie wrap A
Direction of
brand logo
Tie wrap D
Direction of
brand logo
Attach the safety wire to the mounting
w
chassis as shown in the following drawing.
Insert the mounting chassis into the hole
made in Step 1, and put them into the roof
space.
At this moment, the logo direction at
mounting the decorative cover finally can
be aligned with the III direction of the
mounting chassis.
Therefore, if you care about the brand logo
direction, determine the direction using the
III direction.
Safety wire
(accessory)
Cables
Pass the loop
through the tip of
the safety wire.
Direction of brand logo
Tie wrap B
Direction of
brand logo
Tie wrap C
Roof space
Ceiling board
Mounting
chassis
9