Installations - Panasonic WV-Q126A Installationsanleitung

Installations

Be sure to read "Precautions" (☞ page 3) and "Precautions for installation" (☞ page 4) before instal-
lation. Read the operating instructions for the camera to be installed as well.
Step 1
Put Template A (accessory) against the ceiling and
make the ø220 mm {8-21/32 inches} hole.
Step 2
Install two anchor bolts (M10 recommended) into the ceiling.
One anchor is used for securing the mounting chassis, and the other anchor is used for connecting
the safety wire.
Determine the anchor bolt
q
(accessory).
Position the nut by use of Template B (accessory)
w
bottom surfaces of the ceiling board and nut shall be 183 mm {7-7/32 inches}.)
Anchor bolt (for connecting
the safety wire)
Template B
Ceiling board
Important:
• The pull-out strength of the anchor bolt shall be more than 5 times of the total weight of the
installed devices (including the camera body, ceiling mount bracket, anchor bolts, and all other
parts).
• When the existing anchor bolt is used as an anchor bolt for connecting the safety wire, make
sure that the distance between the anchor bolt and camera mounting position is 1 m {3.28 feet}
or less.
(for securing the mounting chassis) length by use of Template B
Anchor bolt (for securing
the mounting chassis)
w Mount a nut
q Determine the anchor bolt length
Install the anchor bolt in the center of the hole
Ceiling face
Template A
and mount the nut. (The distance between the
183 mm {7-7/32 inches}
ø220 mm
{8-21/32 inches}
7