Panasonic WV-Q126A Installationsanleitung Seite 11

Step 8
Loosen the stopper bracket fixing screw, slide
the stopper bracket toward the outside of this
bracket (in the unlock w direction of the label),
and unlock the height adjusting screw.
Height adjusting
screw
Step 9
Rotate the height adjusting screw (one of 4
points) clockwise when viewing it from beneath
(in the e down direction of the label), and
move the camera mounting stage from the
back to the front side. At this moment, the
paper gauge attached to the camera mounting
stage descends together. Be careful to prevent
the cables from being caught between the
mounting chassis and camera mounting stage.
Height adjusting screw
Stopper bracket
Stopper bracket
fixing screw
Camera mounting
stage
Camera mounting stage
Paper gauge
Height adjusting screw (mounting
chassis inside)
Adjustment can be performed with
the height adjusting screw at 1 point.
Tightening torque: 0.1 N·m {0.07 lbf·ft}
* Do not apply equal to or more than 0.29 N·m
{0.21 lbf·ft} of torque. Failure to observe this
may cause damage.
11