Herunterladen Inhalt Inhalt Diese Seite drucken

mixars QUATTRO Bedienungsanleitung Seite 6

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 50
21. Sync Button
Syncronize a track to another by pressing the corresponding «Sync» button and turn off the function by
pressing «Sync» while holding «Shift».
22. Shift button
Hold for enabling the shifted functions of some controls
23. Crossfader Fader Curve switch
Switch among the 3 cross fader settings Hard (towards left) to Soft (towards right) for different
application.
24. Split Cue On/Off switch
If enabled, the headphones signal gets split: Master signal on one channel, and the enabled Cue signals
selected via the «CUE» buttons (see 43), on the other channel.
25. Crossfader Reverse switch
Reverses the Left with the Right Channel on the crossfader.
26. CUE Mix
Turn for adjusting between Cue and Master signal on the headphone output.
27. Upfader Fader Curve switch
Switch among the 3 cross fader settings Hard (towards left) to Soft (towards right) for different
application.
28. Headphones Level
Adjust the headphones volume.
29. Headphones Output connector
6.35mm and 3.5mm jack for connecting headphones
30. Master On CUE switch
Press to enable the Master on CUE headphone channel.
31. Sampler Volume
Control sampler volume level in Serato DJ
32. Crossfader
Crossfade between the Left and Right channels of audio assigned to them by the « Channel assignment
switch» (see 41)
33. FX ON switch
Enable/ disable the FX proceeded signal to the master output.
34. TAP button
Tap to enter manual BPM to the FX unit. Press and hold for 3 sec to enable auto BPM detection.
35. FX CUE switch
Enable/ disable the FX proceeded signal to the headphone cue output.
36. FX Depth parameter knob
Adjust the FX depth or dry/wet of the selected FX.
37. FX Select encoder
Turn to select different FX and press to select.
38. FX Time parameter knob
Adjust the FX time/ beat parameter of the selected FX. Press to switch between Time and Beat
parameter.
39. FX on Channel selector
Select the desired channel to apply the FX.
40. Onboard FX display
Display various information about the FX
41. Channel assignment switch
Assign the corresponding channel to the left or right channel of the corssfader. When "THRU" is selected,
the channel signal will go through to master directly bypassing the crossfader.
42. Channel faders
Adjust the volume level of the corresponding channel.
43. Cue On/Off
Assign the corresponding channel to the Cue signal.
44. Channel Sound Texture FX knob (FILTER)
Adjust the parameter/ level of the selected sound texture FX.
45. Channel level meter
Display the corresponding channel level signal
46. Channel EQ
Adjust the equalizer settings for the corresponding channel
47. Channel Trim
Adjust the overall level for the corresponding channel.
48. Source Switch
Select the input to be controlled on the corresponding channel.
Switch between Phono/Line (see 9), Line (see 8), Serato – USB1 (see 50) or Serato – USB2 (see 49).
For Deck 4, there is an extra input source of MIC 2.
49. USB 2 connector
Connect the mixer to your computer using the included USB cable for using it with Serato DJ. To use this
USB device, use the «Source Switch» (see 48) to select to USB2
50. USB 1 connector
EN 5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis