mixars QUATTRO Bedienungsanleitung Seite 10

In non-Serato mode routing, the Quattro works as a typical external hardware mixer that the mixing is
done by Quattro hardware.
The non-Serato mode Audio routing:
There are different ways to switch between the 2 audio routings:
1. When Serato DJ software is open and initiated, it will trigger the connected Quattro to change to
Serato mode routing automatically.
2. Press and hold the MASTER button and power on the Quattro. Audio routing mode and be
selected and changed by using the FX Select encoder and the current selected mode is shown on
the Display. Turn the FX Select encoder to select desired audio routing and press to confirm and
finish the power on.
3. When the Quattro is powered on and in use, press and hold the 2 SHIFT buttons for 5 seconds, a
system utility menu will be shown on the display. Use the FX Selector Encoder to select to the
Audio routing section and select desired audio routing.
The audio interface is a 10-in 12-out interface with assignment:
CH Inputs
1 Deck 1 in L (DVS)
2 Deck 1 in R (DVS)
3 Deck 2 in L (DVS)
4 Deck 2 in R (DVS)
5 Deck 3 in L (DVS)
6 Deck 3 in R (DVS)
7 Deck 4 in L (DVS)
8 Deck 4 in R (DVS)
9 Record in L
10 Record in R
11 NA
12 NA
13 NA
14 NA
15 NA
16 NA
Outputs
Deck 1 out L
Deck 1 out R
Deck 2 out L
Deck 2 out R
Deck 3 out L
Deck 3 out R
Deck 4 out L
Deck 4 out R
CUE out L
CUE out R
Sampler out L
Sampler out R
NA
NA
NA
NA
EN 9