Leckey Everyday Activity Benutzerhandbuch Seite 18

8.2 Seat base cushion
The seat base cushion can be attached by
simply setting it in place, then pressing down
to locate the snap fasteners (a) at the back of
the seat base, next fold the cover underneath
the front of the seat base and locate the
snap fasteners (b). There is a section of
material located in the centre of the seat
base cushion which can be used to cover the
pommel receiver bracket when the pommel
is not being used. Pull this section of material
down from underneath the seat base cushion
and attach using velcro strips at each side.
When the pommel is in use, tuck this section
underneath the seat base.
A
B
8.3 Chest lateral
support covers
To attach the chest lateral support covers,
simply slide the covers on the lateral support.
Feed the plastic buckle through the slot in
the cover, then bring the two Velcro fastener
straps around the bottom of the moulding
and attach them to the Velcro panel as
shown. Close over the strap.