Connecting Cables - Avigilon 1.0W-H3PTZ-DP20 Installationsanleitung

Connecting Cables

Refer to the camera's Top View on page 2 for the location of the
different connectors.
Make sure the safety lanyard is connected to the PTZ dome camera
before you complete the following cable connections:
1. If there are external input or output devices that need to be
connected to the camera (for example: door contacts,
relays, analog video, speakers, etc), connect the devices
to the camera I/O connector cable.
For more information, see Connecting to External Devices.
2. Connect power using one of the following methods:
•
•
3. Connect the Ethernet Port (RJ45 connector) to a network
using an Ethernet network cable. The Link LED will turn on
once a network link has been established.
4. Check that the Connection Status LED indicates the
correct state.
For more information, see LED Indicators.
Power over Ethernet (PoE) Plus IEEE 802.3at
Class 4 — Connect a PoE Plus compliant injector
or switch to the Ethernet network cable.
External Power — Connect an external "Class 2" or
"LPS" or "Limited Power Source" with output rated
24 VAC +/- 10%, 55 VA minimum or 24 VDC
+/- 10%, 44 W minimum.
For more information, see Connecting External
Power.
7