Safety Notes; Installation Instructions; Symbol Description - HANSGROHE Talis Select S 80 Gebrauchs- Und Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The shower system may only be used for bathing,
hygienic and body cleaning purposes.
The hot and cold supplies must be of equal pres-
sures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be oberserved.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
Technical Data
This mixer series-produced with EcoSmart
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
2
®
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
Assembly (see page 4)
English

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 6)
To adjust the hot water limiter. Using a hot
water limiter in combination with a continu-
ous flow water heater is not recommended.
Dimensions (see page 9)
Flow diagram (see page 9)

‚
Operation (see page 12)
Hansgrohe recommends not to use as drink-
®
ing water the first half liter of water drawn
in the morning or after a prolonged period
of non-use.
Maintenance (see page 8)
Spare parts (see page 10)
Special accessories
(order as an extra)
seal #98996000 (see page 4)
Cleaning (see page 12)
with EcoSmart
®
without EcoSmart
®