Manual Dialing - Kenwood NEXEDGE NX-820G Bedienungsanleitung

DTMF (DUAL TONE MULTI FREQUENCY) CALLS

MANUAL DIALING

1 Press and hold the PTT switch.
2 Enter the desired digits using the microphone DTMF keypad.
• If you release the PTT switch, transmit mode will end even if the complete number
has not been sent.
• If the Keypad Auto PTT function has been enabled by your dealer, you do not need
to press the PTT switch to transmit; you can make the call simply by pressing the
microphone DTMF keys.
■ Store & Send
1 Press the key programmed as [Autodial].
2 Enter up to 30 digits using the microphone DTMF keypad.
3 Press the PTT switch to make the call.
AUTODIAL
Autodial allows you to quickly call DTMF numbers that have been programmed onto your
transceiver.
1 Press the key programmed as [Autodial].
• The fi rst entry in the Autodial list appears on the display.
2 Press the /
• You can also enter a number from 01 ~ 32 directly using the microphone DTMF
keypad.
3 Press the PTT switch to make the call.
■ Storing an Autodial Entry
1 Press the key programmed as [Autodial Programming].
2 Press the
3 Press the S or
4 Press the
5 Press the C> key to accept the entered digit and move the cursor to the right.
• Press the A or # key to delete an incorrect digit. Press and hold the A or # key
to delete all digits.
6 Repeat steps 4 and 5 to enter the entire name.
7 Press the S or
8 Press the
• You can also enter digits directly using the microphone DTMF keypad.
9 Press the S or
• Press the A or # key to delete an incorrect digit. Press and hold the A or # key
to delete all digits.
10 Repeat steps 8 and 9 to enter the entire number.
14
key to select an autodial list number.
/ key to select a memory location number.
key to enter a name for the list number.
/ key to select a digit.
key to accept the name and enter a number.
/ key to select a digit.
key to accept the entered digit.