Signal Strength Indicator; External Speaker; Display Brightness - Kenwood NEXEDGE NX-820G Bedienungsanleitung

SIGNAL STRENGTH INDICATOR

The signal strength indicator displays the strength of received calls. No icon appears when
no signal is available.
Strong
fl ashes when out of range (NXDN Trunking only).
PUBLIC ADDRESS (PA)
The PA system can only be used with an external speaker.
1 Press the key programmed as [Public Address] to activate the Public Address
function.
• The icon appears on the display.
2 Press and hold the PTT switch, then speak into the microphone to make your address
through the external speaker.
3 Press the [Public Address] key again to exit Public Address.
HORN ALERT
When a call is received that matches the optional signaling set up on your transceiver,
Horn Alert causes the vehicle horn or some other external alert to sound. This function
notifi es you of a received call when you are away from your vehicle.
To toggle Horn Alert ON and OFF, press they key programmed as [Horn Alert].
• The icon momentarily appears on the display when Horn Alert is active.

EXTERNAL SPEAKER

When attaching an external speaker to the transceiver via the KCT-60, press the key
programmed as [External Speaker] to output all received signals through the external
speaker.
• The
Press the [External Speaker] key again to output all received signals only through the
built-in speaker.

DISPLAY BRIGHTNESS

You can cycle the display brightness between high, low, and off by pressing the key
programmed as [LCD Brightness].
18
Suffi cient
icon appears on the display.
Weak Very weak