Program And Test The Inclination Angle Detection - Selve commeo Wind Sensor Betriebsanleitung

Setting the parameters wind and inclination
Step 5
Caution!
• Put the housing cover onto the base plate and screw them together.
• Switch on the power.
Warning!
Step 6
Caution!
• Test the function 'retraction' by vertical moving of the drop file.
• Observe the awning characteristics. Do not destroy the awning!
Warning!
• Awning retracts already at low vibrations: Back to step 2
Reduce sensitivity (= set higher values at the step switch).
• Awning does not retract even at strong movements: Back to step 2
Enlarge sensitivity (= set smaller values at the step switch).
Step 7
Test mode terminates automatically after 5 minutes.

7.2. Program and test the inclination angle detection

Step 1
Push the DOWN button at the hand-held transmitter for 1 second:
• Awning has been extended (lower end position).
Step 2
Caution!
• Risk of injury through automatic retraction of the awning!
Warning!
Caution!
• Deenergize the awning (e.g. on the backup device)!
Warning!
31
GB
GB