Program/Re-Program Radio; Program Sensor - Selve commeo Wind Sensor Betriebsanleitung

GB Program/re-program radio

6. 6. Program/re-program radio

For the transmission of the radio signals the motor, hand-held transmitter and commeo
Wind Sensor are matched with each other. To program the radio into the commeo Wind
Sensor, a hand-held transmitter which has already been programmed into the motor
of the respective awning must be available.
Caution!
• Placing into operation: open the housing, insert the batteries in correct
positional arrangement.
Warning!
• Prerequisite for the operation: windstill.
• The test of the inclination angle detection is only possible in non-opera-
ting state, as otherwise the automatic inclination calibration will not be
carried out.

6.1. Program sensor

Caution!
• A hand-held transmitter which is programmed into the awning motor or
receiver is available.
Warning!
• The hand-held transmitter is in operating mode. (please see operating
instructions of the hand-held transmitter).
Step 1
Push the PROG button of a programmed hand-held transmitter for
3 seconds:
• Status LED flashes green for 2 seconds.
• The awning motor is ready to be programmed for 1 minute.
3 s
Step 2
Push the PROG button of the commeo Wind Sensor for 1 second:
• The commeo Wind Sensor is now programmed in the awning motor.
• LED at the sensor flashes for 2 seconds, first orange, then green.
28