Adjusting The Inclination Angle Detection With A Step Switch; Toggle Button; Prog Button - Selve commeo Wind Sensor Betriebsanleitung

GB Device components

2.4. Adjusting the inclination angle detection with a step switch

When a water pocket forms at rain in the awning cloth,
the drop profile bends down slowly. The commeo Wind
Sensor recognizes this change of the inclination angle at
the awning. It compares the change with a preset value.
When the measred value exceeds the preset value, the
commeo Wind Sensor transmits a signal to the motor of
the awning which will be retracted immediately.
Step switch:
• Setting the inclination angle detection in 10 gradations.
• Use a screw driver (max. 0.4 × 2.5 mm blade size ).
• The step switch has no stopper.
• Turn the step switch clockwise
• The delivery status is step '0' (OFF).

2.5. TOGGLE button

Function
Manual operation of the
awning

2.6. PROG button

Function
Programming
Test mode
or
Keypress Effect
1 second DOWN – STOP – UP – STOP – ... etc.
Keypress Effect
1 second Demand to program is sent to the motor
Demand to re-program is sent to the
3 seconds
motor
• Switch on test mode:
· Release time after 'wind alarm'
shortens to 15 seconds
6 seconds
· Test mode will automatically be
terminated after 5 minutes
• Terminate test mode
24
counterclockwise.