Switch Settings - Sw3 - Renishaw NCi-4 Installations- Und Benutzerhandbuch

1-12
Switch bank SW3
Switch
1 M-code 1 active
2 M-code 2 active
3 Not used
4 Not used
NOTES:
If an M-code is not connected to terminal 11,
SW3-1 must be set to 24 V.
If an M-code is not connected to terminal 12,
SW3-2 must be set to 24 V.
Switch settings – SW3
On Off
0 V 24 V Determines whether the input responds to an active-high or
active-low signal.
0 V 24 V As above
– – Not used
– – Not used