Switch Settings - Sw2 - Renishaw NCi-4 Installations- Und Benutzerhandbuch

1-10
Switch bank SW2
CAUTION: With the SSR output
!
switch(es) set to OFF, i.e. normally-open
(N/O), the respective output will remain in a non-
triggered state if the power supply is interrupted
and/or a poor connection is made to the SSR.
Switch On
1 SSR1 N/C
2 SSR2 N/C
3 SSR2 Level
Switch settings – SW2
Off
N/O Sets the SSR output to either normally-closed (N/C) or
normally-open (N/O).
N/O As above
Pulsed Sets the SSR2 output to level or pulsed.