Renishaw NCi-4 Installations- Und Benutzerhandbuch Seite 14

Interface LED states
Five LEDs are fitted on the front of the NCi-4
interface. These provide the operator with a
visual indication of the system status.
Status LED (when used with NC3 or
NC4)
Following a successful set up, the Status LED
indicates the status of the NC system to the
operator. The colours and associated states are
described in the table on page 1-6.
When the system is in the Set-up mode, the LED
changes from red to amber to green as the beam
voltage increases.
If the LED is amber after exiting from the Set-up
mode, this indicates that set-up has not been
successful and must be repeated.
Status LED (when used with NC1)
Green The probe is untriggered
Red The probe is triggered
Interface LEDs
When the system is in the Set-up mode, the LED
displays red.
Aux. relay status LED
Green
Not lit
Tool set mode LED
Green
Not lit
Tool break mode LED
This is the high-speed tool breakage mode.
Green
Not lit
Latch mode LED
Green
Not lit
Auxiliary relay energised
Auxiliary relay not energised
Mode selected
Mode not selected
Mode selected
Not selected
Mode selected
Not selected
1-5