Cleaning Thetransfer Ribbon Drawing Roller; Cleaning The Printhead; Cleaning The Label Photocell - Carl Valentin SPX II Kurzanleitung Und Hinweise Zur Produktsicherheit

Cleaning theTransfer Ribbon Drawing Roller

A soiled print roll can lead to reduced print quality and can affect transport of material.

Open cover of print module.

Remove labels and transfer ribbon form the print mechanics.

Remove deposits with roller cleaner and a soft cloth.

If the roller appears damaged, replace it.

Cleaning the Printhead

CAUTION!
Wrong cleaning auxiliaries can damage the printhead!

Do not use sharp or hard objects to clean the printhead.

Do not touch protective glass layer of the printhead.
Printing can cause accumulation of dirt at printhead e.g. by colour particles of transfer ribbon, and therefore it is necessary to
clean the printhead in regular periods depending on operating hours, environmental effects such as dust etc.

Open cover of print module.

Turn lever counter clockwise to lift up the printhead.

Remove labels and transfer ribbon from the print mechanics.

Clean printhead surface with special cleaning pen or a cotton swab dipped in pure alcohol.

Allow printhead to dry for 2-3 minutes before commissioning the printer.

Cleaning the Label Photocell

CAUTION!
Abrasive cleaning agents can damage the label photocell.

Do not use sharp or hard objects or solvents to clean the label photocell.
The label photocell can become dirtied with paper dust and this can adversely affect label detection.
A

Open cover of print module.

Turn lever counter clockwise to lift up the printhead.

Remove labels and transfer ribbon from the print
mechanics.

Blow out the photocell (A) with the compressed air
B
spray. You have strictly to observe the instructions
mentioned on the can.

Moisten a cleaning card (B) with printhead and roll
solvent to clean additionally the photocell inside.

Reload labels and transfer ribbon.
English
SPX II
137