Loading Label Roll In Peel Off Mode; Loading Label Roll In Passing Mode - Carl Valentin SPX II Kurzanleitung Und Hinweise Zur Produktsicherheit

Loading label roll in peel off mode

J
I
H
G
F E D

Loading label roll in passing mode

E
D
C B A
C B A
English

Open the print module cover.

Open printhead (I) by turning the red pressure lever (J)
anticlockwise.

Lead the label material (minimum height = 15 mm) below the
label guiding (A) and printhead (I) and take care that the
labels run through the photocell (C).

In order to move the printhead (I) down, turn the red pressure
lever (J) in clockwise direction until it locks.

Adjust the adjusting rings (B) of the label guiding to the width
of material.

Lift the dispensing whip (E) to the bottom by turning the stop
lever (G) in clockwise direction to the top.

Strip some labels from the backing paper and lead the
backing material over the dispensing whip (H) and between
the plastic roll (F) and the dispensing whip-shaft (D).

Press again the dispensing whip (D) to the top and lock it.

Lead the supporting paper to the back and fix it at a rewinding
unit.

Enter the offset value in the Dispenser I/O menu.

Close the print module cover.

Open the print module cover.

Open printhead (D) by turning the red pressure lever (E)
anticlockwise.

Lead the label material below the label guiding (A) and
take care that the label runs through the photocell (C).

In order to move the printhead (D) down, turn the red
pressure lever (E) in clockwise direction until it locks.

Adjust the adjusting rings (B) of the label guiding to the
width of material.

Close the print module cover.
SPX II
117