Specifications; Components; Vehicle Preparations; Installing Transmitter Batteries - ECX REVENGE N Bedienungsanleitung

en
transmitter
Frequency
Modulation DSM, DSM2, Marine
Battery
Included Items
1. ECX Revenge Type N
™
2. Spektrum DX2E 2.4GHz transmitter
™
• 3 degree toe set
• Shock spacers
• Air filter assembly
• Turnbuckle wrench
• L wrenches: 1.5, 2 and 2.5mm
needed to complete
• Nitro fuel
• Glow igniter
• 8AA batteries

InstallIng transMItter BatterIes

1. Slide the panel open on the bottom of the
transmitter.
2. Obey the battery plus (+) and minus (-) diagram
in the transmitter to install 4 AA batteries.
3. Slide the panel closed.
We recommend using only alkaline AA batteries
in the transmitter, however, it is possible to use
rechargeable Ni-MH batteries.
cautIon: If using rechargeable batteries, charge
only rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.

transMItter Battery safety PrecautIons

• Never install damaged batteries.
• Never install batteries of mixed types or of different ages
in the transmitter.
4

sPecIfIcatIons

steering servo
2.4GHz Power Supply
Output Torque
AA x 4 Operating Speed 0.20 sec/60 degrees of travel
Size

coMPonents

1/8-scale Nitro Off-Road Buggy
™

VehIcle PreParatIons

1
4.8V~6V (shared with receiver)
199.8 oz-in (8.5 kg-cm)
55.6 x 18 x 30mm
1
2
• Always remove exhausted batteries.
• Always remove batteries before storing the transmitter.
• Low battery power can result in loss of control of the RC vehicle.
throttle servo
Power Supply 4.8V~6V (shared with receiver)
Output Torque 41.66 oz-in (3 kg-cm)
Operating Speed 0.23 sec/60 degrees of travel
Size 55.6 x 18 x 30mm
ST. TRIM
TH. TRIM
2
3
ST. RATE