Specifications; Components; Vehicle Preparations; Installing Transmitter Batteries - ECX ECX0800 Bedienungsanleitung

en
transmitter
Frequency
Modulation
Battery
servo
Power Supply
Output Torque
Operating Speed
Size
Included Items
1. ECX Revenge Type e
™ ™
2. Spektrum DX2E transmitter
™
• 3 degree rear toe set
• Shock spacers
• Turnbuckle wrench
• L-wrenches: 1.5mm, 2mm, 2.5mm
needed to complete
• DYN4108 Prophet Sport Duo
™
Li-Po 50Wx2 Dual Battery Charger
• Dynamite Gold Series
®
2S or 3S Li-Po Battery

InstallIng transMItter BatterIes

1. Slide the panel open on the bottom of the
transmitter.
2. Obey the battery plus (+) and minus (-) diagram
in the transmitter to install 4 AA batteries.
3. Slide the panel closed.
We recommend using only alkaline AA batteries
in the transmitter, however, it is possible to use
rechargeable Ni-MH batteries.
cautIon: If using rechargeable batteries, charge
only rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
4

sPecIfIcatIons

DSM, DSM2, Marine
4.8V~6V (shared with receiver)
199.8 oz-in (8.5 kg-cm)
0.20 sec/60 degrees of travel
55.6 x 18 x 30mm

coMPonents

1/8-scale Buggy

VehIcle PreParatIons

1
electronic speed control (esc)
2.4GHz Input Voltage
Constant/Peak
AA x 4 Resistance
Overload Protection
BEC Voltage
Size
Weight
1
2
7.4–14.8V
130 A/760 A
0.0004 Ohm
Thermal
6V/3 A
53.5mm x 36mm x 36mm
79 g
ST. TRIM
ST. RATE
TH. TRIM
2
3