Using The Remote Controls; Adjusting The Air Flow - Technibel MPW Serie Bedienungsanleitung

5 - USING THE REMOTE CONTROLS

5.1 - MANUAL OPERATING MODE INVERSION CONTROL (70250076)
1 - Operating switch with fan speed selection.
2 - Temperature setting knob.
3 - Operating mode selector switch.
Heating
Cooling
Caution: Before selecting the operating mode, make sure that the temperature of the
water in the installation corresponds with the mode required. If not, the thermostat cannot
ensure its operation correctly.
5.2 - AUTOMATIC OPERATING MODE INVERSION CONTROL
(70250051)
1 - Operating switch with fan speed selection.
2 - Temperature setting knob.
3 - Cooling on indicator light.
4 - Ventilation on indicator light.
Note: When this light is fl ashing it means that the fan is currently shutting down.
5 - Heating on indicator light.
Caution: With this control, Heating/Cooling mode selection is made automatically.

6 - ADJUSTING THE AIR FLOW

6.1 - HORIZONTALLY
• The air fl ow can be adjusted horizontally
by moving the vertical fi ns to the right or
to the left.
• In cooling operation, do not turn the fi ns
completely to the left or right. Doing so
may cause condensation to form which
could fall to the fl oor.
6.2 - VERTICALLY
• The fl ow of air can be regulated by moving
the fl ap upwards or downwards.
• In cooling mode, do not direct the damper
downwards more than 30° so as to avoid
the formation of droplets of condensation
which could fall on the fl oor.
6.3 - RECOMMENDED POSITION FOR THE DAMPER
MPW
Area "A"
for cooling
30¡
A"
LEFT
Vertical fi ns
UPWARDS
Damper
DOWNWARDS
Air inlet grilles
Area "B"
for heating
60¡
"B"
MPW
RIGHT
RIGHT
LEFT
KPSW
MPW
UPWARDS
DOWNWARDS
KPSW
"A"
Area "A" for cooling
"B"
Area "B" for heating
1
3
2
5
4
3
1
2
KPSW
"A"
"B" 30¡
3
F
GB
I
E
D