Safety Instructions; Using The Remote Control Unit - Technibel SCDV106C5VA Bedienungsanweisungen

Install a double - pole switch, protected fuses of the delayed type,
upstream the electricity wall socket 10A.
Make sure that circuit breakers, fuses, etc. are of sufficient
capacity to handle start - up current (normally for no longer than
a second).
All wiring must conform to the local electrical codes. Consult your
dealer or a qualified electrician for details.
EG

SAFETY INSTRUCTIONS

Read this booklet carefully before using this air conditioner.
If you still have any difficulties or problems, consult your
dealer for help.
This air conditioner is designed to give you comfortable
room conditions. Use this only for its intended purpose as
described in this Instruction Manual.
WARNING
Never use or store gasoline or other flammable vapour or liquid
near the air conditioner. It is very dangerous.
Moreover, never install electrical equipment, which is not
protected with IPX1 protection (protection against vertical
water drop), under the unit.
The manufacturer assumes no responsibilities if the safety
regulations or local codes are not observed.
CAUTION
Never use the power main switch to start or stop the air
conditioner: always use the ON/OFF button
Do not stick anything into the air outlet of the air conditioner.
This is dangerous because the fan is rotating at high speed.
Do not let children play with the air conditioner.
Do not cool the room too much if babies or invalids are
present.

USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES
Remove the lid in the rear part of the remote control unit.
Insert two AAA alkaline batteries of 1,5 V-DC.
Make sure the batteries point in the direction marked in the
battery compartment.
The batteries last about six months. Depending on how much
you use the remote control unit.
Remove the batteries if you do not use the remote control unit
for more than one month.
Press the +, -, SET and CLEAR buttons together after batteries
replacement.
(This operation allows you to reset correctly all the programs.
The remote control unit is to be set up again).
Replace the batteries when the remote control unit lamp fails
to light, or when the air conditioner does not receive the remote
control unit signals.
The batteries of the remote control contain polluted substances
exhausted batteries must be disposed according to the laws
in force.
TEMPERATURE SENSOR SELECTOR
Under normal conditions the room temperature is detected and
checked by the temperature sensor placed in the air conditioner.
Press the remote control I FEEL button to activate the
temperature sensor placed in the remote control. This function
is designed to provide a personalised environment by transmitting
the temperature control command from the location next to you.
Therefore, in using this function, the remote control should
always be aimed, without obstruction, at the air conditioner.
NOTE
The remote control unit sends the
temperature signal to the air
conditioner regularly at two
minute intervals. If the signal from
the remote control unit stops for
more than five minutes due to
some troubles, the air conditioner
will switch to the temperature sensor which is built into the
indoor unit and controls the room temperature. In these
cases, the temperature around the remote control unit may
differ from the temperature detected in the air conditioner
position.
OPERATION WITH THE REMOTE CONTROL UNIT
When using the remote control unit, always point the unit transmitter
head directly at the air conditioner receiver.
REMOTE CONTROL UNIT
4
REMOTE CONTROL UNIT
DISPLAY
INDOOR UNIT
RECEIVER
TRANSMITTER HEAD