Dimplex DEC 1802 Gebrauchsanweisung Seite 9

Setting a temperature limitation/child protection
The meaning of display indications
Saving energy
Performance indicator
Pre-warmed water
Service
You also have the option of limiting the temperature to 42 °C.
Switching on the "Symbol key"
I
Briefly press buttons
key" appears in the display and the temperature is limited to
42 °C.
Switching off the "Symbol key"
I
Briefly press buttons
key" disappears in the display and the temperature is now freely
selectable.
Mixing in of cold water in the fitting requires unnecessary water and
energy. You should therefore set the desired water temperature
directly on the continuous-flow heater and then open the water tap.
If "eco" lights up in the display it means that the appliance is being
run economically.
The performance indicator (status bar in display) shows the current-
ly used performance of the continuous-flow heater in 10 % incre-
ments.
Example: 7 increments are shown while drawing off hot water. This
means that the continuous-flow heater is currently only running at
70 % of its maximum output.
If the set temperature cannot be reached because the water
throughput is too high, the continuous-flow heater will automatical-
ly adjust the water throughput until the set temperature is achieved.
The continuous-flow heater can be operated with pre-warmed wa-
ter (for example from a solar energy unit) up to a max. of 55 °C.
The "Symbol Sun" will appear in the display if the feed water tem-
perature is above 30 °C.
Please try to eliminate the fault according to guidelines given in the
chapter "A fault, what to do" if "service" lights up in the display.
and simultaneously. The "Symbol
and simultaneously. The "Symbol
9